HORN All Electric Furnaces
HORN builds a wide variety of glass furnace types for its customers, ranging from the usual end fired furnace to the all electric melting furnace. Furnace selection depends on individual customer requirements and demands.
In general all electric furnaces with a cold top are used typically for a production range of 5 – 80 t/d with the possibility given to increase the melting capacity up to 200 t/d (or even beyond that). For this furnace type energy is not supplied by means of fossil fuels, but exclusively by means of electric energy supplied by molybdenum electrodes.
The melting, refining and homogenising processes in all electric furnaces are typically happening in a vertical direction, in contrast to the horizontal direction for fossil fueled furnaces.
In all electric furnaces the batch layer is the focal point in operating the furnace. A delicate balance for the batch thickness must be found to prevent high energy losses on the one side and an improper melting process on the other side. For this reason the flexibility in regards to pull changes and culet fraction is restricted, but can be improved by means of furnace design.
The specific pull is higher and not comparable with fossil fuel fired furnaces due to vertical melting process. The glass quality can be drastically higher than in a fossil fuel fired furnace. For this reason, high quality specialty glass, e.g. for optical applications, is often molten with all electric furnaces.
The energy consumption of all electric furnaces is lower than the one of fossil fired furnaces. This advantage is especially true for furnaces with small pull rates, making them even more cost efficient. Increasing costs for CO2 allowances can be a deciding factor for all electric furnaces despite higher costs for electric energy in the near future.
FEATURES
- Reduced dusting of the batch due to missing flame gases
- Usage of a very cheap bag filter system is possible
- Suitable for production of special glass with expensive, volatile and aggressive components in the batch
- No emissions due to firing (NOx, CO2)
- Shorter lifetime and thus shorter time until improvement
- Short time from glass to glass in case of brick to brick repair
Join us at glasstec 2024 to talk about the possibilities of using electric energy in glass melting in the form of HORN hybrid furnaces, super hybrid furnaces or all electric melting furnaces.
Further information at Furnaces (hornglass.com)
14.08.2024, HORN
printNews material on the Site is copyright and belongs to the Company or to its third party news provider, and all rights are reserved. Any User who accesses such material may do so only for its own personal use, and the use of such material is at the sole risk of the User. Redistribution or other commercial exploitation of such news material is expressly prohibited. Where such news material is provided by a third party, each User agrees to observe and be bound by the specific terms of use applying to such news material. We do not represent or endorse the accuracy or reliability of any of the info contained in any news or external websites referred to in the news.
Should the content or the design of these sites violate third parties rights or legal prescriptions, we kindly ask you to send us a respective message without invoice or cost. We guarantee that passages where the claim is considered as justified will be removed immediately, without any necessity to involve any lawyer into this issue. We will reject any claim caused by submission of a honorary note in this regard without any prior contact and confirmation of the issueby us and we reserve the right ssue counter claim ourselves because of violation of aforesaid conditions.
