PLUNGER MECHANISM IWS
Main Data
Available for SG, DG TG on all IS machines sections (4”1/4 – 5” – 5”1/2 – 6”1/4)
Total compatibility with standard cartridges
Same limit range as standard plunger mechanisms
Technical Features
SG - DG - TG mechanisms share the same base plate and the same centering plate;
Enhanced air duct for counterblow and plunger cooling;
High temperature polymer seals;
Sensors and electronic components positioned out from mechanism that do not interfere with the mechanical components
Benefits
Enhanced counterblow in Press-blow process due to smoother seals;
Better performance due to the increased air ducts and more performing seals;
Job change faster and easier because base plate and centering plate don’t need replacement
03.05.2022, BDF
printNews material on the Site is copyright and belongs to the Company or to its third party news provider, and all rights are reserved. Any User who accesses such material may do so only for its own personal use, and the use of such material is at the sole risk of the User. Redistribution or other commercial exploitation of such news material is expressly prohibited. Where such news material is provided by a third party, each User agrees to observe and be bound by the specific terms of use applying to such news material. We do not represent or endorse the accuracy or reliability of any of the info contained in any news or external websites referred to in the news.
Should the content or the design of these sites violate third parties rights or legal prescriptions, we kindly ask you to send us a respective message without invoice or cost. We guarantee that passages where the claim is considered as justified will be removed immediately, without any necessity to involve any lawyer into this issue. We will reject any claim caused by submission of a honorary note in this regard without any prior contact and confirmation of the issueby us and we reserve the right ssue counter claim ourselves because of violation of aforesaid conditions.