Apart from access to the necessary knowhow, glass container quality is only as good as the quality of equipment and materials employed. Optimal production conditions need detailed attention to mould equipment design and materials. So let’s evaluate what’s behind sophisticated mould design co-operation and the benefits afforded to container manufacturers.
When the production of a new bottle or jar is planned, besides the mould design itself, attention should be focused on the container design. It depends on the type of container and whether empirical data (weight analysis, deformation studies etc) are already available or comparable. Heye International specializes in the knowhow necessary to handle new designs.
In the case of traditional and lightweight container designs alike, Heye uses the Finite Element Method (FEM), deriving values relating to the internal pressure situation, head load and impact stress test. This FEM is a simulation software that ultimately reveals if the container with the stipulated weight and wall thickness data meets the filler’s requirements.
As an alternative, for ultra-lightweight containers, Heye offers customers the support of a pre-test under real production conditions, either at the customer’s production site or at a glass plant within the Ardagh Group.
CO-OPERATION BENEFITS
When it comes to the design of moulds and plungers for new containers, Heye works together closely with its sister company UniMould, which has considerable long-term experience in the manufacture of NNPB/PB plungers, plugs and cooling tubes.
Several years ago, UniMould developed a special and well-proven plunger coating. Together with the high quality mould and plunger material, this coating optimizes the impact and internal pressure condition of the container. Damage to a container’s internal surface is avoided by this special plunger material and coating combination.
“This co-operation has resulted in a market leadership position with regard to the performance and stability of glass containers” says Knut Prasuhn, Head of the Service Department at Heye International. “Our customers benefit from this ‘one-stop’ service and co-operation, generating a wide diversity of valuable experience.”
22.07.2019, Heye International GmbH
Les informations publiées sur notre portail sont soumises au droit d´auteur et appartiennent à la société en question resp. à la source des nouvelles. Tous les droits sont réservés expressément. N´importe quel utilisateur qui accède à un tel matériel peut faire ainsi seulement pour sa propre utilisation personnelle, et l´usage d´un tel matériel est au risque unique de l´utilisateur. La redistribution ou toute autre exploitation commerciale d´un tel matériel de nouvelles est expressément interdite. Là où un tel matériel de nouvelles est fourni par un tiers, chaque utilisateur accepte d´observer et être lié par les limites spécifiques de l´utilisation s´appliquant à un tel matériel de nouvelles. Glass Global ne représente ou n´approuve pas l´exactitude ou la fiabilité d´aucune des informations citées dans les nouvelles ou pages externes auxquelles on se réfère ici.
Should the content or the design of these sites violate third parties rights or legal prescriptions, we kindly ask you to send us a respective message without invoice or cost. We guarantee that passages where the claim is considered as justified will be removed immediately, without any necessity to involve any lawyer into this issue. We will reject any claim caused by submission of a honorary note in this regard without any prior contact and confirmation of the issueby us and we reserve the right ssue counter claim ourselves because of violation of aforesaid conditions.